Making a solar tv for dollhouse from vintage coaster holder

This is a vintage coaster holder. You can use any coaster cabinet for the tv. 

This is what the inside looks like with the doors open.

This is plastic I got from a throw away container, I like to use these for a lot of my projects.

You need to cut a piece of the plastic to fit the size of the opening. Remember you need to have the doors to be able to close.

You will also need two pieces of wood.  They will be on the front plastic area. You will see in the pictures.

I had this picture which was part of a card that had a kitty on it. It's made of transparent plastic so I had to also cut a piece of paper for in back of the picture. So you need a piece of the plastic, a piece of white paper and the picture.  They all need to be the same size.

First is the plastic piece from container, on top of that you glue down the piece of white paper and then the kitty. In another blog I show you how to make a solar tv out of a picture you would download off the computer, you can check that one out also.  Let’s get back to this one.

Now you need to glue the two pieces of wood on the piece you just put together, you can see this in the photo.

Next, go on the internet to find images. Print out a picture of a tv panel, you will be using this next.

On the one piece of wood, you will be cutting the tv panel out of the printout and gluing it to the wide piece of wood.  On the thinner piece of wood, cut out a piece of the brown area on the picture and glue it down using tacky glue.

On the panel I cut a piece of wood dowel making a circle that could make the dial 3D, I covered it with aluminum foil or you can paint it silver I then glued it over the picture of the tv knob.  The line on top of the knob is a piece of a round toothpick which I also glued down and drew a black mark on it.  I then glued this whole piece to the inside of the coaster holder as you can see in the photo.  To make it easier what I do with my projects is put tacky glue in different areas of the piece and then putting dots of hot glue in the areas that don’t have tacky glue on it.  The tacky glue keeps the piece in its spot while the glue is setting.

Here’s what it looks like with the doors shut.  Next is the solar light getting installed to light it up.

In the back of the cabinet you need to drill a hole the size of the LED on the solar light so it can slide right in and be held into place.  If the solar light keeps sliding out use some black electrical tape to make it tighter.

In Walmart and the dollar tree you can buy cheap single solar lights. All you need is the top part of the light, with the solar cell and the LED.  But remember don’t throw out the other piece you need to recharge the solar panel for it to light up.

After putting the solar light into the hole in the back, this is what it looks like with the doors opened.

This is what it looks like with the doors shut. Use your imagination put in any picture maybe use a picture of a family member etc.. Use your imagination and it will soar!